Connecting your alfapilot to a computer, proceed to copy all the contents of the internal memory, to restore it once you have reseted our alfapilot.From SeRi Fly, export your configuration (Settings -> System -> Export configuration), as well as export your fly book, and your “INTERNAL” thermal package.If we still want to perform the restoration of our alfapilot, consider making backup copies, for this: The contents of the internal memory will be deleted, including tracks, maps, flight book, settings, etc, from SeRi Fly.
In this case, as indicated by this procedure, all personal data and downloaded applications will be deleted, this action can not be reverse. This option is available on “Aplications -> Settings -> Backup & Reset”. (SRF) Settings: Pilot Data – Wing Data – System (3:00 Minute) We also have a video tutorial on this same page where you can see the procedure. Now we can also adjust the lower bar to our liking, so that the vario is more or less reactive. If it is not and continues to fluctuate erratically, we will repeat the 1st step.ģº Once the line that represents the vario is centered, we will try to raise and lower our alfapilot, a fluctuation like the one in the following image should be shown. Finally with our alfapilot over a table (to avoid vertical movements), press the “Calibrate” button as shown in green arrow 3.Ģº Once the calibration has been carried out, the line that represents the vario must be similar to that of the following image. Next we adjust the lower bar to approximately middle, as shown by green arrow 2. To adjust the vario, we must select “Kalman Filter (B)” as shown by green arrow 1. Probably is necessary a vario re-calibrating, for this we will access the Kalman filter settings (SeRi Fly -> Settings -> System -> Kalman Filter Settings).ġº Once we access, we may see that the line that represents the various, probably fluctuate erratically, is indicated in the following image with red arrows.
#GPSBABEL INVALID RETURN DATA AT LINE 3 INSTALL#
If when connecting our alfapilot the system shows an unknown device message, or requires us to install drivers, we will proceed to download the drivers and install them in the system.We can see when the is connected, the green charging LED should also light up, located to the right of the power button. If when connecting our alfapilot the system does not show any message or recognize it, we can try another micro-USB cable.Depending the operating system you use there may be diferent solutions:
0 kommentar(er)
